Omnitronic VRM-100 PRO Bedienungsanleitung

USER'S MANUAL
STUDIO MICROPHONE
Ribbon Microphone for excellent sound
The VRM-100 PRO was designed for professional studio recording
Professionald Ribbon Microphone with figure 8 pattern
2" aluminium ribbon (2.5 micron thick)
Ideal for recording studios, accoustic instruments, strings, horns, orchestras, e-guitars, drum
overheads and choral groups
Particularly suitable for recording musical instruments with high SPL and large dynamic range
Balanced XLR output
Delivery incl. shockmount and padded wooden box in carrying box
Safety Instructions
Maintenance and service operations are only to be carried out by authorized dealers. Damage,
caused by manual modifications on this device is not subject to warranty. If the microphone is used for
other purposes than originally intended or if it is not correctly connected, the product may suffer
damages and the guarantee becomes void.
Protect the device against humidity and heat. The ambient temperature must always be between
-5° C and +45° C. The relative humidity must not exceed 50 % with an ambient temperature of 45° C.
Setting into Operation
Screw the shock mount on your microphone stand and insert the VRM-100 PRO from above.
Connect the microphone to the XLR microphone input of your audio unit (e.g. mixing console) using a
balanced microphone cable with 3-pin XLR plug.
For voice recordings, always use a windshield to protect the capsule from moisture.
Cleaning and Maintenance
For cleaning the microphone only use a soft lint-free and moistened cloth. Make sure not to allow any
water to enter the device and never use any solvent cleansers.
© Copyright
Nachdruck verboten!
Reproduction prohibited!
or live performances.
Delivery Includes
Technical Specifications
Ribbon type/Dimensions (LxW): ............2.5 microns pure aluminum/35 x 5 mm
Polar pattern: .........................................Figure 8
Frequency range: ..................................30 Hz - 15,000 Hz, ±3 dB
Nominal impedance: .............................<600 Ohms
Load impedance: ..................................3000 Ohms
Max. SPL:..............................................148 dB (THD 1% @ 1 kHz)
Equivalent SPL: ....................................18 dBA
Sensitivity:.............................................-54 dB
S/N ratio: ..............................................70 dB
Connection: ..........................................3-pin XLR, balanced
Dimensions (Ø x L): ...............................37 x 175 mm
Weight: .................................................500 g
frequency response (figure 8)
Please note: Every information is subject to change without prior notice. 10.05.2007 ©
VRM-100 PRO
VRM-100 PRO Ribbon Microphone
Shock mount
Foam-lined wooden box
polar pattern (figure 8) at 1 kHz
13030822_V_1_0.DOC
www.omnitronic.com