Omnitronic VM-2000 Bedienungsanleitung

USER'S MANUAL
STUDIO MICROPHONE
Professional Condenser Microphone
The VM-2000 condenser microphone was designed for professional studio recording and live
applications. The microphone operates on 48 V phantom power.
Large-diaphragm condenser microphone for high-quality studio and live applications
Perfect for direct or overhead sound pick-up of acoustic and electric instruments and vocals
Particularly suitable for recording musical instruments with high SPL (up to 145 dB) and large
dynamic range
Switchable high pass filter and input attenuation (-10 dB)
Well-balanced frequency range for natural sound
Balanced XLR output
Requires +48 V phantom power
Safety Instructions
Maintenance and service operations are only to be carried out by authorized dealers. Damage
caused by manual modifications on this device is not subject to warranty. If the microphone is
used for other purposes than originally intended or if it is not correctly connected, the product may
suffer damages and the guarantee becomes void.
Protect the device against humidity and heat. The ambient temperature must always be between -5°
C and +45° C. The relative humidity must not exceed 50 % with an ambient temperature of 45° C.
Setting into Operation
Screw the shock mount on your microphone stand and insert the microphone from above. In case
of stands with 9 mm (3/4") thread fix the clamp via the supplied adapter screw.
Connect the microphone via a balanced microphone cable with 3-pin XLR plug to the XLR
microphone input equipped with +48 V phantom power of your audio unit (e.g. mixing console). If the
audio unit does not provide any phantom power, connect the microphone to the audio unit via a
phantom power supply unit (e.g. OMNITRONIC LH-051).
The microphone is equipped with a switchable high pass filter and input attenuation. Set the left
switch to " " to activate the filter and attenuate low frequencies. Set the right switch to "-10 dB" to
attenuate the sensitivity by 10 dB.
For voice recordings, use the supplied windshield to protect the capsule from moisture.
© Copyright
Nachdruck verboten!
Reproduction prohibited!
Cleaning and Maintenance
For cleaning the microphone only use a soft lint-free and moistened cloth. Make sure not to allow any
water to enter the device and never use any solvent cleansers.
Technical Specifications
Type:...................................Condenser
Directivity pattern: ...............Cardioid
Frequency range:................20 Hz - 20 kHz
Sensitivity: ..........................-35 dB
W
Output impedance: .............<250
Max. SPL: ...........................135 dB/ 145 dB (switchable)
Equivalent SPL: .................16 dBA
S/N ratio:.............................78 dB
Phantom power:..................+48 V DC
Connection: .......................3-pin XLR, balanced
Weight: ...............................578 g
[dB] -20
-30
-40
-50
-60
20 50 100 200 500 1K
[Hz]
frequency response (cardioid)
Please note: Every information is subject to change without prior notice. 10.06.2008 ©
VM-2000
Delivery Includes
Condenser microphone
Spider shock mount
Stand adapter (3/8" to 5/8")
Windshield
Foam-lined flight case
330 30
300
270
240
210 150
2K 5K 20 K
180
polar pattern (cardioid) at 1 kHz
13030830_V_1_0.DOC
www.omnitronic.com
60
90
120