Installation - BMW F 46 0448 EVA Montageanleitung

The installations instructions should be handed over to the customer.

Installation

Installation time approx. 10 minutes.
The installation time can vary according to vehicle condition and equipment.
Open fold-put page 1-9.
In some cases installation is represented on one side of the vehicle only. Proceed in a corresponding way for
the other side of the vehicle.
A
Put the rear-compartment protective cover (a) over the front seat headrests (1).
B
The rear-compartment protective cover is made so that you can still use the outer seat belts even with the
rear-compartment protective cover in place.
To do this, guide the appropriate seat belt buckle (2) through the opening in the rear-compartment protective cover
(a).
Insert the tabs (3) between the backrest and the rear seat bench.
C
Put the rear-compartment protective cover (a) over the rear-compartment headrests.
D
If you are using one or both of the outer seat belts, lay the appropriate seat belt(s) (4) over the rear-compartment
protective cover (a)
E
Insert the retaining tabs (5) between seat back and side part and close the Velcro fastener (6).
F
Turn up the side part of the rear-compartment protective cover (a) and fasten the Velcro fastener (7) to the backrest
part.
G
Fasten the Velcro fastener (8) in the area of the front seats to the rear side of the rear-compartment protective
cover (a).
The rear-compartment protective cover is not waterproof and merely serves as a protection against unwanted
impurities such as dog hair, sand, or similar.The rear-compartment protective cover offers inadequate protection
against liquids of any kind.
1-2/EN