Werbung
Verfügbare Sprachen
Verfügbare Sprachen
supplies with an output of at
least 1 amp. For more informa-
tion on LGB power supplies for
indoor, outdoor and multi-train
operation, see the LGB catalog.
Attention! After extended opera-
tion, this model may leave carbon
dust or other debris around the
track. This dust and debris can
stain carpet and other materials.
Consider this when setting up
your layout. Ernst Paul Lehmann
Patentwerk and LGB of America
are not liable for any damages.
SERVICE
Do-It-Yourself Service Levels
Level
- Beginner
Level
- Intermediate
Level
- Advanced
Attention! Improper service will
void your warranty. For quality
service, contact your authorized
retailer or an LGB factory service
station (see Authorized Service).
Hint: Additional expert instruc-
tions for many LGB products are
available at www.lgb.com.
Lubrication
The axle bearings should be lubri-
cated occasionally with a small
amount of LGB Maintenance Oil
(50019).
Cleaning
This model can be cleaned exter-
nally using a mild detergent and
gentle stream of water. Do not
immerse this model.
Replacing the light bulbs
Front and rear lanterns:
We recommend installation of
these parts at an authorized LGB
service station. For quality ser-
vice, contact your authorized
retailer or an LGB factory service
station (see Authorized Ser-
vice).
Interior lights
- Remove the main roof panel by
pushing up on the panel with a
finger through an opening door.
- Carefully pull the lighting circuit
board off the mounting posts.
10
:
- Replace the bulbs.
- Reassemble.
Maintenance parts
50019 Maintenance Oil
51020 Gear Lubricant
62206 20640-Series Motor
63120 Brushes, Assembled
14 mm and 16 mm,
8 pieces
68511 Plug-In Bulb, Clear, 5 V,
10 pieces
68512 Plug-In Bulb, Red, 5 V,
10 pieces
INSTRUCTIONS FOR
ADVANCED USERS
MTS Onboard Decoder
Programming functions
You can program numerous func-
tions of the onboard decoder to
suit your requirements. If you
want to do this, program the
"function values" in "registers"
(CVs) using a PC and the 55045
MTS PC Decoder Programming
Module. You can also program the
function values using a 55015
Universal Remote.
Hints:
- For normal operation, it is not
necessary to change the func-
tion values.
- If programming results in unsat-
isfactory operation, you can
reprogram the factory pre-set
values of most important CVs:
Program register CV55 to func-
tion value 55. This also repro-
grams the loco address to the
factory pre-set value.
To reprogram the factory pre-set
function values with the 55015
(displays shows "P --") input 6, 5,
and 5 and press the right arrow
button. The display shows "P --"
again: Input 5, 5, and 5 and press
the right arrow button again.
You can program the following
registers:
Werbung
