AEG AIK2023R Benutzerinformation Seite 16

16 www.aeg.com
Problem
Door does not open easily.
The lamp does not work.
There is too much frost and
ice.
Water flows on the rear plate
of the refrigerator.
There is too much con‐
densed water on the rear
wall of the refrigerator.
Water flows inside the refrig‐
erator.
Possible cause
You attempted to re-open
the door immediately after
closing.
The lamp is in stand-by
mode.
The lamp is defective.
The door is not closed cor‐
rectly.
The gasket is deformed or
dirty.
Food products are not wrap‐
ped properly.
Temperature is set incorrect‐
ly.
Appliance is fully loaded and
is set to the lowest tempera‐
ture.
Temperature set in the appli‐
ance is too low and the am‐
bient temperature is too
high.
During the automatic de‐
frosting process, frost melts
on the rear plate.
Door was opened too fre‐
quently.
Door was not closed com‐
pletely.
Stored food was not wrap‐
ped.
Food products prevent the
water from flowing into the
water collector.
The water outlet is clogged.
Solution
Wait a few seconds between
closing and re-opening of
the door.
Close and open the door.
Contact the nearest Author‐
ized Service Centre.
Refer to "Closing the door"
section.
Refer to "Closing the door"
section.
Wrap the food products bet‐
ter.
Refer to "Control Panel"
chapter.
Set a higher temperature.
Refer to "Control Panel"
chapter.
Set a higher temperature.
Refer to "Control Panel"
chapter.
This is correct.
Open the door only when
necessary.
Make sure the door is closed
completely.
Wrap food in suitable pack‐
aging before storing it in the
appliance.
Make sure that food prod‐
ucts do not touch the rear
plate.
Clean the water outlet.