To examine the water connection
CAUTION: If there is a leakage of water
from the water connection ring, the shaft
seals must be replaced immediately.
•
Let an approved Husqvarna service center repair the
water connection.
To examine the carbon brushes
1. Remove the 4 screws that hold the cover for the
carbon brushes. Use a flat wide screwdriver. (Fig.
28)
Troubleshooting schedule
If you cannot find a solution to your problems in this
operator's manual, speak to your Husqvarna service
agent.
1188 - 009 - 12.10.2020
2. Examine the carbon brushes. The area of wear must
be smooth and not damaged.
3. If it is necessary, let an approved Husqvarna service
center replace the carbon brushes.
Troubleshooting
15