Outwell Deep Chill 29 Bedienungsanleitung Seite 6

4.5 Cool box mode settings:
• Cool box mode selection:
There are two working modes in this device:
HH working mode: the cool box will work normally in this mode.
The LED light "on" will be red in this working mode.
ECO working mode: the cool box operation will be energy saving.
The LED light "on" will be green in this mode.
Touch the button "set" twice continually, this will show "HH" or "ECO" on the display. Now use the
button "UP +" and "DOWN -" to select the mode you what. The working mode letter "HH" or "ECO"
will flash in the screen for a few seconds, and then the display screen will return to display the
current temperature.
4.6 The explanation for the running code shown in the display screen:
Error Code Possible Reason
E0 Sensor circuit is broken or short
E1 Input voltage is low
E2 Ventilating fan problem
E3 Compressor started self-protection
E4 Compressor protect itself against
unusual running speed.
E5 Control panel's overheating warning
4.7 Energy saving tips:
• Choose a well-ventilated and isolated location which is protected against direct sunlight.
• Allow warm food to cool down before placing it in the cool box.
• Do not open the cool box more often than necessary.
• Do not leave the cool box open for longer than necessary.
• Defrost the cool box once a layer of ice forms.
• Avoid unnecessary low temperatures.
5. CONNECTING THE COOL BOX:
WARNING! DC extension cord
• Because of the potential safety hazards under certain conditions, the manufacturer does not
recommend using any type of DC extension cord.
• Under no circumstance should you attempt to split extension cord wires.
• Do not use power strips or two-way splitters.
• Always unroll or uncoil a DC cord to avoid heat retention and possible melting.
Connecting to a battery (vehicle or boat), the cool box can be operated with DC 12V or 24V.
Suggested Solution
Connect or replace the sensor
Check the battery voltage or adjust the
Battery Monitor Level.
Check if the ventilating fan is blocked or
short circuit.
Disconnect the device from power supply
for 30 minutes, and re-start the device.
Change the working mode by device
control panel
Move the device to a place with
well-ventilated installation environment.
6