Assembly Instruction; Manual Cutting - Scantool SC 125V Gebrauchsanweisung

2-5. Assembly Instruction

This view shows the:
A Machine body
B Handle
C Switch (ON/OFF)
D Turnswitch for RPM
E Rod
F Locking handle

MANUAL CUTTING

For the spring!
You have to tighten the screw (E) to make the
steel plate (F) approximately 45 degrees
Fig 6
To start the machine move switch (Fig 6) to ON (I)
position.
Press the button (B of Fig 5) while manual cutting
This machine provides cutting without cooling, so the heat in
the saw blade will be increased while operating.
The machine must not be used more than 70 min. without
stop.
! ! !
WARNING: WHEN THE TOOL IS NOT IN USE, THE SWITCH SHOULD BE
STOPPED BY PRESSING THE (O) BUTTON ON Fig 6
26
Fig 16
Fig 17
! ! !