Correct Positioning Of The Material In The Clamp - Scantool SC 125V Gebrauchsanweisung

Correct positioning of the material in the
clamp
Material to be cut must always be held firmly in the
clamp, directly between the two jaws and without
inserting other objects. Is the profile flat, bars, or
particular shapes, refer to the Examples in Fig 1
When cutting long materials, use roll stand as
support.
Choosing the blade Fig 2
Warning:
NEVER USE BANDS WHICH ARE DAMAGED OR DEFORMED.
NEVER CLEAN THE SAW BAND WHILE IT IS IN MOTION
The choice of the right blade and its toothing depends on the type of material you have to cut
and on its section. Your band saw is fitted with a 1440mm x 13mm, 0.65mm thick metal
blade. However blades with 6 or 14 teeth per inch are also available for special cutting
requirements, indicated in the "cutting table" (fig 2).
30
50
115 MAX
30
40
115 MAX
25 x 35
40 x 50
115 x 153 MAX
Fig 13
23
8/12
6
50 x S5 MAX
6
8/12
6
6
8/12
6
6
Fig 12
30 x S1
40 x S2
30 x S1
50 x S2
14
14
8/12
14
14