afx light PARLED100-Z Bedienungsanleitung Seite 6

Dimmer mode 1
Optically Linear
Mode 1(Optically Linear): The increase in light intensity appears to be linear as DMX value is increased.
Mode 2(Square Law): Light intensity control is finer at low levels and coarser at high levels.
Mode 3(Inverse Square Law): Light intensity control is coarser at low levels and finer at high levels.
Mode 4(S-curve): Light intensity control is finer at low levels and high levels and coarser at medium levels.
Dimmer Speed
Select , press the ENTER button. Use the DOWN and UP button to select
(Smooth). Once selected, press the ENTER button to setup or exit menu mode without any change after 8 seconds. Back to
the functions without any change press the MENU button again.
DMX State
Select , press the ENTER button. Use the DOWN and UP button to select
(Hold the last state) . Once selected, press the ENTER button to setup or exit menu mode without any change after 8 seconds.
Back to the functions without any change press the MENU button again.
DISPLAY INVERSE
To select Disp, press the ENTER button to show the DISPLAY on the display. Use the DOWN/UP button to select
(normal) or
press MENU button.
Manual mode
Select , press the ENTER button. Use the DOWN and UP button to select
strobe(S000-S100). Once selected, press the ENTER button to setup or exit menu mode without any change after
8 seconds automatically. Back to the functions without any change press the MENU button again.
©Copyright Lotronic 2018
Dimmer mode 2
Square Law
(inversion), press ENTER button to setup. Back to the functions without any change
PARLED100-Z
Dimmer mode 3
Inverse-Square Law
Dimmer mode 4
S-Curve
(Fast) or
(Blackout) or
the brightness (d000-d100)or
6