Philips FC9160 Bedienungsanleitung Seite 17

HEPA 13 ilter
The HEPA 13 ilter is able to remove 99.95% of all particles down to
0.0003mm in size from the outlet air. This not only includes normal house
dust, but also harmful microscopic vermin such as dust mites and their
excrements, which are well-known causes of respiratory allergies.
Note: To guarantee optimal dust retention and performance of the vacuum
cleaner, always replace the HEPA ilter every 2 years with an original Philips
ilter of the correct type (see chapter 'Ordering accessories'). You can dispose
of the old ilter with the normal household waste.
Replacing the HEPA 13 ilter
Open the ilter grille.
1
Take out the washable HEPA 13 ilter.
2
Put the ilter back into the appliance.
3
Close the ilter grille and push the bottom corners until they snap
4
home.
Note: For optimal results, replace the HEPA 13 ilter every 2 years. If you want
to minimise the impact on the environment, you can wash the HEPA 13 ilter.
Washing the HEPA 13 ilter (FC917x series only)
To wash the HEPA 13 ilter, follow the instructions below.
Rinse the HEPA 13 ilter under a hot slow-running tap.
1
Never clean the ilter with a brush.
Carefully shake the water from the surface of the ilter. Let the ilter
2
dry completely for at least 2 hours before you put it back into the
vacuum cleaner.
Note: Cleaning does not restore the original colour of the ilter, but does restore
its iltration power.
English
17