Preparation For Disposal; Disposal; Disposal Of The Device - Bauhaus 27615616 Originalbetriebsanleitung

GB
English
Error/Faults
Only the first section of the
jack pressure bar is rising.
The pressure bar does not
go down when the switch is
set to the 'Down' position.
Please contact the store directly if you can-
not eliminate the error by yourself. Please
remember that repairs carried out by non-
professionals will invalidate your warranty
claim and may cause additional costs.

Preparation for disposal

NOTICE! Pollution! The device is
filled with a given amount of spe-
cial oil. Repairs which require the
oil container to be opened should
only be carried out by the manufac-
turer or their customer service part-
ner.
Guidelines with regards to oil dis-
posal when the device is scrapped
must be followed.
46
Cause
The ambient temperature is
too low, causing the hydrau-
lic liquid in the cylinder to
thicken.
The safety valve screw is
loose.
The vehicle is too heavy.
The jack has been running
for too long and has over-
heated.
The inflation equipment/jack
switch is either set to OFF or
to the inflation equipment
position.
The pressure bar is jammed. Loosen the safety valve

Disposal

Disposal of the device

The symbol of the crossed-out dust-
bin on electrical and electronic
devices, and/or the packaging or
accompanying documents for such
devices, means that the device must not be
disposed of together with other waste.
Users are responsible for disposing of used
devices at designated collecting points in
order to guarantee that they are then pro-
cessed appropriately.
You can find information about available
collecting systems for used electrical and
electronic devices at the information desk
in stores and local administrative offices.
Appropriate handling of the used device
guarantees that any hazardous sub-
stances, mixtures or components which
may be present will not enter the environ-
ment or affect human health, thereby ena-
bling the recycling of valuable secondary
raw materials.
Every user of electrical and electronic
devices should endeavour to protect the
environment from harmful waste.
Remedy
Warm up the 2-in-1 device
for 1 hour.
Tighten the safety valve
screw.
Reduce the load and move
the jack to another lifting
point on the vehicle.
Take a break for 15-20 min-
utes.
Set the switch to the jack po-
sition.
screw to allow the pressure
bar to retract.
27615616