TechniSat HDTV 46 Schnellstartanleitung Seite 20

Format change / Zoom / PiP / PaP / Freeze image
6.10 Format change/Zoom
> Pressing the Zoom/Format key runs through the various pre-defined formats
(original, optimal, always 16:9, full zoom and stretch) and calls the user-defined setting,
in which you can adapt the screen according to your requirements.
The following options are available to adapt the picture to your requirements
using the user-defined setting:
red/green control key
yellow/blue control key
Arrow key up/down
OK key
Arrow key left
> Press the Return key, in order to fade out the format change-over.
6.11 PiP-/PaP Function
Your TV set is equipped with both the PiP function (PiP = Picture in Picture)
as well as the PaP function (PaP = Picture and Picture).
6.11.1 Calling the PiP-/PaP Function
> You can turn the PiP and/or PaP function on by pressing the PIP key.
6.11.2 Exchanging PiP-/PaP pictures
> Press the Return key to swap the two pictures.
The PiP-/PaP picture becomes the main picture and vice versa.
6.11.3 Turning the PiP-/PaP Function off
There are two possibilities to turn the PiP and/or PaP function off. These differ in whether after
leaving the PiP /PaP mode the main picture or the PiP /PaP picture is to be represented on the screen.
> Pressing the PIP key fades out the main picture and the PiP /PaP picture
is now represented as the new main picture.
> Press the TV/Radio key, in order to fade out the PiP /PaP picture
and to display the main picture on the entire screen.
6.12 Freeze image
> Press the Freeze image key to display the TV picture as a frozen image.
The sound continues to be transmitted unchanged.
> Pressing this key again terminates the freeze image and the TV picture is shown as normal.
Increase/reduce picture height
Increase/reduce picture width
Move picture up/down
Run through zoom levels
Resetting picture settings
20