Selecting The Programme - TechniSat HDTV 46 Schnellstartanleitung

6.2 Selecting the programme

6.2.1 By means of the programme up/down keys
> You can move up and down through the programmes by one programme position
respectively with the Programme +/- key on the remote control/on the set
6.2.2 By means of the numeric keyboard
> Enter the required programme number by means of the numeric keyboard.
For example:
1
1, then 4
2, then 3,
1, then 2,
When entering multi-digital programme numbers, you have approximately three seconds time after
pressing a key to complete the input. If you only want to enter one-, two-, or three-digit figures, you
can accelerate the procedure by pressing the last number longer or by pressing the OK key.
6.2.3 By means of the programme list
> Press the OK key.
The programme list is displayed. Only TV programmes are displayed in the TV mode and
only radio programmes in the radio mode. The currently set channel has been marked.
6.2.3.1 Selecting the programme
> By means of the Arrow keys or numeric keyboard, you can now select the required programme.
Use the up/down arrow keys to move the marker by one line and use the left/right arrow keys
to page forwards and backwards in the list.
> You can obtain additional information on the current broadcasts by pressing the INFO key.
> To leave the Navigator, press the OK key; the selected programme is now displayed on the screen.
1) Only possible with the remote control for HDTV 32 Plus and HDTV 40 Plus.
then 4
then 4, then 5
for programme position 1
for programme position 14
for programme position 234
for programme position 1245
15
Programme selection
.
1)