Inhaltsverzeichnis
Werbung
(9-pin USB_10_11)
(see p.2 No. 24)
USB 3.0 Header
(19-pin USB3_2_3)
(see p.2 No. 9)
Infrared Module Header
(5-pin IR1)
(see p.2 No. 28)
Consumer Infrared Module Header
(4-pin CIR1)
(see p.2 No. 27)
Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.2 No. 31)
Downloaded from
www.Manualslib.com
USB_PWR
P-11
P+11
1
P+10
P-10
USB_PWR
1
ID
IntA_P3_D+
IntA_P3_D-
GND
IntA_P3_SSTX+
IntA_P3_SSTX-
GND
IntA_P3_SSRX+
IntA_P3_SSRX-
Vbus
IRTX
1
IRRX
ATX+5VSB
1. High Definition Audio supports Jack Sensing, but the panel wire on the
chassis must support HDA to function correctly. Please follow the
instruction in our manual and chassis manual to install your system.
2. If you use AC'97 audio panel, please install it to the front panel audio
header as below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for HD audio panel only. You don't need
to connect them for AC'97 audio panel.
ASRock X79 Extreme3 Motherboard
manuals search engine
GND
DUMMY
GND
Besides two default USB 3.0
IntA_P2_D+
ports on the I/O panel, there is
IntA_P2_D-
one USB 3.0 header on this
GND
IntA_P2_SSTX+
motherboard. This USB 3.0
IntA_P2_SSTX-
GND
header can support two USB
IntA_P2_SSRX+
3.0 ports.
IntA_P2_SSRX-
Vbus
This header supports an
+5VSB
DUMMY
optional wireless transmitting
and receiving infrared module.
GND
This header can be used to
connect the remote
IRRX
GND
controller receiver.
1
IRTX
This is an interface for front
panel audio cable that allows
convenient connection and
control of audio devices.
33
Werbung
Inhaltsverzeichnis
