Installation Steps - Scandomestic SFO 4801 Bedienungsanleitung

Tension adjustment of the door spring
• The door springs are set at the factory to the proper tension for the
outer door.
• If aesthetic wooden panel are installed, you will have to adjust the
door spring tension.
• Rotate the adjusting screw to drive the adjustor to strain or relax
the steel cable.
• Door spring tension is correct when the door remains horizontal in
the fully opened position, yet rises to a close with the slight lift of a
finger.

Installation steps

1 Connect the inlet hose to the cold water supply
2 Connect the drain hose. Refer to diagram
3 Connect the power cord
4 Affix the condensation strip under the work surface of cabinet.
Please ensure the condensation strip is flush with edge of work sur-
face.
5 Place the dishwasher into position.
6 Level the dishwasher. The rear food can be adjusted from the front
of the dishwasher by turning the Allen screw in the middle of the
base of dishwasher use an Allen key. To adjust the front feet, use a
flat screw driver and turn the front feet until the dishwasher is level.
7 The dishwasher must be secured in place. There are two ways to do
this:
Normal work surface: Put the right(left) installation hook into the
slot of the right(left) side plane and secure it to the work surface
with two woodscrews.
Marble or granite work top: Bend the right(left) installation hook
into right-angle,and put it into the slot of the right(left) side plane
and secure it to the work surface with two woodscrews.
8 Bend the brackets of kick board according the depth to inserted to
the base , then fix the brackets to the kick board.
9 Insert the brackets to base of the dishwasher.