Installation Instructions; Aesthetic Panel's Dimensions And In- Stallation - Scandomestic SFO 4801 Bedienungsanleitung

Installation instructions

Disconnect electrical power and electrical equipments before installing
dishwasher. should be done by qualified professionals. Failure to do so
can result in death or electrical shock.
Preparation
The installation position of dishwasher should be near the existing water
inlet tap and drain outlet and power socket. One side of the cabinet sink
should be chosen to facilitate the connection of drain hoses of the dish-
washer.
Positioning the appliance
Position the appliance in the desired location. The back should rest
against the wall behind it, and the sides, along the adjacent cabinets or
wall. The dishwasher is equipped with water supply and drain hoses that
can be positioned to the right or the left to facilitate proper installation.
Leveling of the dishwasher
It is important that the dishwasher is leveled. Use if necessary. a spirit
level inside the machine, both in depth and width and vertically on the
outside closed door.
The rear, right and left feet can be adjusted.
Dishwasher should be placed near the existing inlet and outlet hose and
power cable.
One side of the cabinet sink must be selected to facilitate the connection
of drain hoses dishwasher.
Note: Check the included installation accessories (aesthetic panel hooks,
screws)
Please read the installation instructions carefully Illustrations of the cab-
inet dimensions and mounting position for the dishwasher
Preparations must be made before moving the dishwasher to the instal-
lation site.
1 Select a location near the sink to facilitate the installation of inlet
and outlet hoses
2 If a dishwasher is installed in the corner of the cupboard, there
should be some space when opening the door.
Cabinet dimensions Less than 5mm between the top of dishwasher and
cabinet and the outer door aligned to cabinet.
Minimum space when the door is opened
Aesthetic panel's dimensions and in-
stallation
The aesthetic wooden panel could be processed according to the Figure
The aesthetic panel should be processed in accordance with the illus-
trated dimensions
Install the hook on the aesthetic wooden panel and put the hook into
the slot of the outer door of dishwasher. After positioning of the panel,
fix the panel onto the outer door by screws and bolts
Installation of aesthetic panel
1 take away the four short screws
2 pin up the four long screws