AXTON AXB25P Bedienungsanleitung Seite 6

mouNtING
Note that the amp-module generates heat, so a well ventilated mounting place
n
is necessary or it will easily overheat.
Keep the wire connections as short as possible, with sufficient length, in order to
n
minimize power losses and provide a higher audio output of the system.
For safety reasons route all power and speaker wiring by using the existing
n
wire channels.
To minimize damage to the cables, take care that they do not pass through sharp
n
edged metal. Use rubber grommets were required.
Lay all cables as far away as possible from the ignition cables, modules in the boot
n
and under the dashboard, as these create interference.
add a main fuse (60 a) to the (+) power cable in a distance of not more than
n
30 cm from the positive battery pole (fire hazard!)
Keep the length of the power cable as short as possible.
n
The power cable should have at least a cable cross section of 10mm
n
AWG). Smaller cross sections are reducing the output power, are causing
distortions and may be triggering the overheat protection of the amp-module.
1. Position the mounting brackets.
2. Use the tapping screws to fix them.
– 6 –
(8 Gauge
2