Modes Of Operation - novaer INUK 3.5 CH01 Bedienungsanleitung

1. COOLING MODE (COOL)
• When switched on for the first time, the air conditioner operates in the ventilation mode.
• Press the MODE button to select the cool function.
• The "Cool" LED on the control panel turns on.
• The adjustable temperature range extends from 16 ° C to 30 ° C.
• I n this operating mode, the device saves the entered temperature each time it is switched off with the ON / OFF
button and retains it when it is switched on again.
• In this operating mode the fan speed as well as the timer and SLEEP function can be set.
• Set the speed to minimum (low) for quieter operation.
2. HEATING MODE (HEAT)
• The „Heat" LED on the control panel turns on.
• The temperature setting interval ranges from 16 °C to 30 °C.
• I n this operating mode, the device saves the entered temperature each time it is switched off with the ON / OFF
button and retains it when it is switched on again.
• In this operating mode, the fan speed as well as the timer and SLEEP function can be set.
• Set the speed to minimum (low) for quieter operation.
3. DRY MODE
• Press the MODE button to select the dehumidification operating mode.
• The temperature is controlled by a circuit board and cannot be set.
• I n this operating mode, the device saves the settings each time it is switched off with the ON / OFF button and
retains them when it is switched on again.
• The speed of the fan is specified and cannot be set.
NOTE:
The air conditioner does not cool the room if it works in the dehumidify function.
If the device is used as a dehumidifier, the exhaust hose does not have to be connected.
For maximum dehumidification, leave the exhaust air connection on the back free so that the device can discharge
the air directly into the room.
The dehumidification operating mode is recommended in autumn and winter.
When using this function in summer, the exhaust air hose should be connected so that the warm air is discharged
outside and not into the room.
The permanent drain should be selected during dehumidification (see the section REMOVING THE CONDENSE
WATER below).
4. FAN ONLY VENTILATION MODE
Press the MODE button to select the ventilation function until the corresponding symbol no longer lights up.In diesem
Betriebsmodus kann die Gebläsegeschwindigkeit (Fan Speed) eingestellt werden. However, it is not possible to regulate
the temperature.
This device allows the condensed water to evaporate automatically in cooling mode.
When the air conditioner is operating in cooling mode, the continuous drain does not need to be connected; Water can
only accumulate in the device under special climatic conditions, when the air humidity is very high. When the internal
tank is full, the air conditioner emits 8 beeps; the display shows the message H8 and thus the full container. Operation
of the device is then blocked.
V 20/03

MODES OF OPERATION

REMOVE CONDENSATION
EN
33