novaer INUK 3.5 CH01 Bedienungsanleitung Seite 31

USE OF THE DEVICE WITH WINDOW ADAPTER (energeti cally recommended)
1. T o drill the hole in the glass, it is advisable to use the
accessories for the glazing window.
3. Place the round connector on the hose.
5. Place the fl at connector on the Hose on.
7. The height of the drain from the fl oor must be 40 to 130 cm. Avoid excessive bending or bending of the hose.
OK
8. I f you are not going to use the device for a long ti me, take the hose out of the window adapter and close it with the
cover.
Connect the mains cable to a suitable socket (230 V). Put the supplied batt eries in the
Remote control and pay att enti on to the polarity. Select the desired operati ng mode using the remote control.
V 20/03
2. Place the adapter in the window.
4. I nsert the adapter into the window without the cover.
6. P ush the fl at connector from top to bott om into the
60 cm
Insert the round connector for the window adapter set
into the retractable hose andinsert the retractable hose
with the round connector into the window adapter.
slots (A) and fasten it with the hook (B). The side of
the connecti on pointi ng upwards is marked with the
inscripti on TOP.
B
A
NO
TOP
EN
31