novaer INUK 2.6 C01 Bedienungsanleitung Seite 27

USE OF THE DEVICE WITH WINDOW ADAPTER (energeti cally recommended)
1. To drill the hole in the glass, it is advisable to use the
accessories for the window glazing.
3. Place the round connector on the hose.
5. Place the fl at connector on the Hose on.
7. The height of the drain from the fl oor must be 40 to max. Amount to 130 cm. Avoid excessive bending or bending of
the hose.
OK
8. If you are not going to use the device for a long ti me, take the hose out of the window adapter and close it with the
cover.
Connect the mains cable to a suitable socket (230 V). Put the supplied batt eries in the
Remote control and pay att enti on to the polarity. Select the desired operati ng mode using the remote control.
2. Place the adapter in the window.
4. Insert the adapter into the window without the
cover. Insert the round connector for the window
adapter set into the retractable hose and insert the
retractable hose with the round connector into the
window adapter.
6. Push the fl at connector from top to bott om into
the slots (A) and fasten it with the hook (B). The
upward-facing side of the connecti on is marked with
the inscripti on TOP.
B
A
NO
TOP
EN
27