Comfort Heat Comfort ECO Bedienungsanleitung Seite 5

rather set at the lowest possible setpoint / frost protection when heat is not
required.
Notice:
• The language used in the original documentation is English. Other language
versions are a translation of the original documentation.
• Comfort Heat LTD cannot be held liable for any errors in the documentation.
Comfort Heat LTD reserves the right to make alterations without prior notice.
2. INSTALLING THE SENSOR
• Insert the cable and sensor into a non-conductive conduit embedded in the
floor.
• The end of the conduit must be sealed and the conduit placed as high as
possible in the concrete layer.
• The floor sensor must be centred between loops of heating cable.
• The sensor cable may be extended with additional two-core cable (max.
sensor extension, see Technical Specifications).
• The two wires from the sensor to the thermostat must be kept separate from
high-voltage wires/cables. Place the sensor cable in a separate conduit or
segregate it from power cables in some other way. Ensure that the insulation
on both electrical wiring and floor sensor inside the junction box are not
damaged. Never use two vacant wires in a multi-core cable.
3. PLACEMENT OF THE THERMOSTAT
The thermostat must be mounted on the wall 1.4 - 1.6 m above the floor in such a
way as to allow free air circulation around it. Draughts and direct sunlight or other
heat sources must be avoided.
4. PREPARING THE THERMOSTAT FOR MOUNTING
• Switch off the thermostat
• Grasp the thermostat with one hand, holding the (closed) front with your
thumb on one side and your index and middle finger on the other side. The
bottom of the thermostat should be facing you.
• Insert a small screwdriver into the hole to the right, in the bottom of the
thermostat.
5