Electronic thermostat Comfort ECO
with floor temperature sensor
This high-quality thermostat is designed to have a minimum of impact on the
environment and will at the same time provide long-lasting heating comfort.
Comfort Heat LTD hereby declares that the product conforms with the following
directives of the European Parliament:
LVD - Low Voltage Directive
EMC - Electromagnetic Compatibility
RoHS - Restriction of the Use of Certain Hazardous Substances
WEEE - Waste Electrical and Electronic Equipment
Applicable standards:
CE: EN 60730-1, EN 60730-2-9 This thermostat can be used as a controller for
electric room heating pursuant to EN 50559.
1. IMPORTANT SAFETY INSTRUCTIONS
Warning:
•
To avoid electric shock, disconnect the heating system power supply at the
main panel before carrying out any work on this thermostat and associated
components.
•
Protection against electric shock must be guaranteed by appropriate
mounting. The requirements of Class II are fulfilled after appropriate
mounting (reinforced insulation).
•
Installation must be carried out by qualified personnel in accordance with
appropriate statutory regulations (where required by law).
•
Installation must comply with national and/or local electrical codes.
Caution:
•
These instructions must be observed, otherwise the liability of the
manufacturer shall be voided.
•
Any changes or modifications made to this thermostat shall void the liability
of the manufacturer.
•
Maximum product lifetime is achieved if the product is not turned off - but
EN
3