Fcc Notices (Usa, Canada); China - IFM Electronic efector190 DTS125 Montageanleitung

12.1.3

FCC Notices (USA, Canada)

This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry
Canada. Operation is subject to the following two conditions:
(1) this device must not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
Warning:
Changes or modifications made to this equipment not expressly approved by ifm
electronic gmbh may void the FCC authorization to operate this equipment.
Note:
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and receiver.
● Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
● Consult the dealer or an experienced radio/TV technician for help.
12.1.4

China

The "Type Approval Certificate" is available on our website at:
→ Data sheet direct → e.g. DTA100 → Approvals
www.ifm.com
24