Fimor P 344 Gebrauchsanweisung Seite 18

ERRORS AND ALARMS
SIGNAL DISPLAY
Er1 TEMPERATURE
ALL TEMPERATURE
PF TEMPERATURE
All alarms are accompanied by an intermittent acoustic signal produced by the buzzer (one 3-
second beep every 10 seconds). The buzzer can be silenced by pressing the ARROW DOWN
button
Er1. This alarm occurs in the event of a malfunction of the cooking chamber probe. The
TEMPERATURE display reads Er1 and the buzzer sounds. The cooking cycle stops.
Remedy: replace the cooking chamber probe.
ALL. Safety thermostat alarm. In the event of a thermostat alarm, the TEMPERATURE
display reads ALL and the TIME display is off. The cooking cycle stops and the
buzzer sounds.
When the alarm stops (reset using the button under the base of the oven on the
rear), press the ON/OFF button to reset the alarm. The oven is now turned OFF.
Remedy: If the alarm persists, contact customer support or the retailer.
PF. Signal after a reset due to power failure. Press any button to stop.
DIAGNOSTICS
1. Power failure
Following a power failure, the machine is reset. If a cycle was in progress prior to the
power failure, it resumes from the point where it was interrupted.
2. Probes Alarm
2.1. Chamber probe
A problem with the chamber probe causes the cycle in progress to stop. The
TEMPERATURE display reads "ER1" and the buzzer sounds continuously. The buzzer
can be silenced by pressing any button.
2.2. Electronic Board Overtemperature Probe
A problem with the overtemperature probe causes the cycle in progress to stop. The
TEMPERATURE display reads "ER2" and the buzzer sounds continuously.
3. Door Opening
Opening the door causes the cycle to stop and disconnects the output contacts. The
light remains switched on. When the door is closed again, the cycle resumes from the
point at which it was interrupted.
CAUSE
Problem with
chamber probe
Safety thermostat
Power Failure
EFFECT
the Current cooking cycle interrupted
Current cooking cycle interrupted.
Reset by pressing the button under
the oven.
Signal only.
18