Appendix A: Technical Specifications - Beta 1760DGT/2 Benutzerhandbuch

Appendix A: Technical Specifications

All specifications herein mentioned apply to the series oscilloscopes. Before checking an
oscilloscope to see if it complies with these specifications, make sure it meets the following
conditions:

The oscilloscope must have been operating continuously for twenty minutes under the
specified operating temperature.

The Do Self Cal operation must be performed through the Utility menu if the operating
temperature changes by more than 5℃.

The oscilloscope must be within the factory calibration interval.
All specifications are guaranteed unless noted 'typical'.
Oscilloscope Specifications
Horizontal
Band Width
Rising time
Sample Rate Range
Waveform Interpolation
Record Length
SEC/DIV Range
Vertical
A/D Converter
VOLTS/DIV Range
Measurement Range
Selectable Analog
Bandwidth Limit, typical
Low Frequency Response
(-3db)
Rise Time at BNC, typical
DC Gain Accuracy
Note: Bandwidth reduced to 6MHz when using a 1X probe.
Acquisition
Acquisition Modes
40MHz
≤8.75ns
250MSa/s(Single-channel), 125MSa/s(Dual-channel)
(sin x)/x
Max. 6K samples for single-channel,
3K samples per dual-channel
5ns/div~500s/div 1, 2, 5 sequence
8-bit resolution, each channel sampled simultaneously
10mV/div~10V/divat input BNC
±5div
20MHz
≤10Hz at BNC
≤5ns
±3% for Normal or Average acquisition mode, 10V/div to
10mV/div
Normal
80