Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ENGLISH
the required length and insert the plug into the
socket.
Yellow mark on the power cord indicates the
maximum cord length. Do not unwind the power
cord further than the red mark.
Attention!
Always switch the vacuum cleaner on with
–
the installed cloth dustbag (21) and filters
(22, 24) in it.
Note:
Inside the compartment there is a block
(20) that does not allow to close the lid, if
the dustbag (21) is not installed or installed
improperly; always check if the dustbag is
installed correctly before closing the lid.
1. Press the on/off button (17) to switch the
vacuum cleaner on.
2. During the operation you can control the
suction power by turning the power control
handle (15) or the mechanical control (6) on the
handle of the flexible hose (4).
3. After the room cleaning press the on/off button
(17) and remove the power plug from the socket.
4. To wind the cord press the cord winding button
(16), hold the winding cord with hand in order to
avoid its whipping and damage.
Maintenance
If full dustbag indicator (14) turns red during
operation, clean up or replace the dustbag. To do
this, switch the vacuum cleaner off and unplug it,
then clean or replace the cloth dustbag.
Provide that the inlet filter (22) is always clean,
because the overall performance of the vacuum
cleaner depends on it; clean the filter no less
than 3-4 times a year, and more often at severe
obstruction. Replace the filter (22) as and when
required.
Cleaning the inlet filter (22)
•
Switch the unit off and unplug it.
•
Open the dustbag compartment lid (13) by
pulling the clamp (11) and remove the dust-
bag (21).
•
Remove the inlet filter (22) pulling it upwards.
MW-3205.indd 10
•
Wash it with warm water, dry carefully and
install back to its place.
•
Install the dustbag (21).
•
Close the dustbag compartment lid (13).
Cleaning the outlet filter (24)
•
Switch the unit off and unplug it.
•
Open the outlet filter compartment lid (25) by
pressing the clamp downwards, then remove
the filter (24).
•
Wash the filter (24) under slightly warm water
jet Do not wash filter in a dish washing
machine.
•
Dry the filter. Do not dry the filter with a hair
dryer.
•
Install the filter into the outlet filter compart-
ment.
•
Close the lid (25).
The body of the vacuum cleaner
•
Wipe the vacuum cleaner body with a soft
damp cloth
•
Provide that no water gets inside the unit.
•
Never use solvents or abrasives to clean the
surface of the vacuum cleaner.
Storage
Before taking the vacuum cleaner away for
–
storage clean its body, the cloth dustbag (21)
and the filters (22, 24).
For easy storing use the brush storage space
–
(18).
Keep the vacuum cleaner away from children
–
in a dry cool place.
Delivery set
1. Vacuum cleaner (with the filters and the cloth
dustbag installed) –1 pc.
2. Flexible hose –1 pc.
3. Carpet/floor brush –1 pc.
4. Combined attachment –1 pc.
5. Instruction manual –1 pc.
Technical specifications
Power supply: 220-240 V ~ 50 Hz
Power consumption: 1400 W
Suction power: 260 W
Cloth dustbag 1 l
10
31.01.2013 14:30:29
Werbung
