Quick Operation - Swim & Fun Frisbee FX2 Betriebsanleitung

4.2. Quick operation

Plug in the cleaner using the supplied adapter and charging line to charge the battery.
Note
When charging, it is strictly forbidden to leave the pool robot upsidedown to
prevent the swing plate from being crushed.
• Power off the cleaner before charging.
• Clean the charging port before charging.
• Red charging indicator indicates the battery is charging.
• Green charging indicator indicates charging is finished.
Put the cleaner into water and let it stand vertically under the water for 5-6 seconds to
dischargethe air inside it. Press the switch to power on the cleaner. and lower the pool
robot horizontally to the pool floor.
The cleaner will stop running after completing the working cycle. The floating handle can
be hooked by a hook with a lengthened connecting rod, and the cleaner is pulled to the
edge of the pool.
Power-off operation
A sound signal comes when lifting the pool robot out of the pool. Press theswitch to OFF
and the cleaner will be shut down. Always clean the filter tray after use.
4.3. Functions and adjustment of wheels
There are 4 wheels on the cleaner, of which the left and right wheels are fixed. The front
and back wheels can be selectively adjusted according to different conditions so as to
adjust the running path of the cleaner.
MV-1940-9-2019 . swim-fun.com © Alle rettigheder forbeholdes Swim & Fun Scandinavia ApS
MV-1940-9-2019-Pool-Robot-Frisbee-BOG.indb 63
UK
63
18/09/2019 10.57