Mounting Process; Ethernet Connection - OSRAM e:cue SYMPL Installationsanleitung

4.2

Mounting process

The SYMPL Switch is designed to mount onto a 35mm DIN rail (EN 60715)
in a vertical position:
Use a 3 to 3.5mm screw for the hanger hole.
For mechanical stability, mounting on a rail is recommended.
4.3

Ethernet connection

The pin-assignment of the Ethernet ports correspond to RJ45 standards.
You can use every common Ethernet component, like cable, splitters, and
switches. Connect the SYMPL Switch at the designated Ethernet interfaces
with patch cables (RJ45, CAT5).
i
The Ethernet port of the SYMPL Node is not designed for
inter-building connections with power and lighting transients.
Use only intra-building networks to connect the SYMPL
Nodes and Cores.
1. Clip the device to the rail from
top.
2. Apply gentle pressure to the
top front to snap it in place. The
SYMPL Switch has been
mounted successfully.
You can also mount the
SYMPL Switch on any flat surface.
Installation
13