BOMANN bs 980 cb Bedienungsanleitung Seite 33

Winding
Press the cable winding button and guide the cable. Hold the
cable to avoid wrapping.
Telescope Vacuum Pipe
Nozzle accessories
Groove and brush nozzle:
Upholstery nozzle:
Floor nozzle:
Releasing the nozzles:
Air Slide
Open the air slide on the hose handle in order to regulate the
airfl ow or to clear any particles sticking to the nozzle.
05_BS 980 CB 33
• The height-adjustable vacu-
um pipe enables individual
alignment to your height.
• Unlock the coupling by pres-
sing the key in the direction
of the arrow.
• Slide the vacuum pipe to the
desired length.
• To lock the device, release
the key until you hear it lock
in place.
For vacuuming upholstery, cur-
tains and in corners and crevices
etc.
„2-in-1" nozzle: When this is
folded together it can be used as
a groove nozzle. If you would like
to use the brush nozzle, pull the
brush section in the direction of
the arrow until it locks in place.
For cleaning upholstery, curtains
etc.
To clean carpets or smooth
surfaces.
In order to facilitate control, the
fl oor nozzle is fi tted with rollers
and can be adjusted to suit the
circumstances.
Carpet: make sure that the
brushes on the fl oor nozzle
are deactivated when cleaning
carpets. If this is not the case,
press the lever on the fl oor nozzle
forwards with your foot.
In order to vacuum even
surfaces, for example, press the
lever back with your foot. This
activates the brushes (you can
tell whether this is the case by
checking that the brushes are
visible on the fl oor nozzle).
Pull these off while turning
slightly.
Filter System or Dust Bag
You can operate your vacuum cleaner with the dust fi lter system
or a conventional dust bag. For this you will fi nd the dust bag
carrier among the accessories.
Dust Bag
If the fi lling level indicator (1) lights up the dust bag has to be
replaced.
•
•
Illustration A
•
•
•
Illustration B
Dust Filter System
• Your device also has a dust fi lter system. The conventional
dust bag can b replaced by a dust container.
• In this, coarse dirt particles and tiny particles fl oating in the
air are swirled out of the suction air by the high speed of the
air current.
• The purchase of dust bags is no longer necessary.
NOTE:
If you would like to use the dust container the dust bag carrier
has to be removed from the device beforehand.
Removing the Dust Container and Filter
If the fi lling leve indicator (1) lights up the dust container needs
emptying.
Please proceed as follows:
•
•
Illustration C
Pull the plug out of the
socket.
Open the lid of the dust
compartment with the button
(5) (see illustration A).
Pull the dust bag out of the
holder (see illustration B).
Insert a new dust bag.
Close the cover so that it
snaps into place.
Open the lid of the dust
compartment with the button
(5) (until its locks in place).
Lift out the dust container
by pulling upwards (see
illustration C).
33
04.05.2007, 14:35:56 Uhr