Fuse Holder; Rf Connectors - Input - Rohde & Schwarz ZVA-Z90E Handbuch

®
R&S ZVA-Z90E / -Z110E
To supply the frequency converter with power, connect the external DC power supply
to the "9 V / MAX. 1.1 A" DC input (labeled "9 V / MAX. 1.6 A" on R&S ZVA-Z500 con-
verters). For details, see
on page 16.
Always switch the instrument to standby state before removing the power supply.
Risk of instrument damage
The input voltage and current must not exceed the maximum values according to the
rear panel labeling or the data sheet.
Notice that the external DC power supply units of R&S ZVA-Z500 converters support
higher output powers. Always use the DC power supply delivered with your frequency
converter.

2.3.3 Fuse Holder

The power supply connector at the rear panel is protected by a fuse of type IEC60127
T1 L/H (IEC60127 T1.8 L/H on R&S ZVA-Z500 converters). For fuse replacement, see
Chapter 2.4.10, "Replacing
2.3.4 RF Connectors – Input
Two 3.5 mm input connectors:
●
RF IN (RF source signal input)
●
LO IN (local oscillator signal input)
For correct cabling, please refer to
on page 13.
Getting Started 1307.7197.62 ─ 08
Chapter 2.4.7, "Connecting the Converter to the DC
Fuses", on page 18.
Chapter 2.4.6, "Connecting RF
Preparing for Use
Rear Panel
Supply",
Cables",
9