BOMANN bs 969 cb Bedienungsanleitung Seite 41

Winding
Press the cable (4) winding button and guide the cable. Hold the cable to avoid
wrapping.
Nozzle Attachment
Crevice, brush and
jointed nozzle:
Floor nozzle:
Releasing the nozzles:
Air Slide
Open the air slide on the hose handle in order to regulate the airfl ow or to clear
any particles sticking to the nozzle.
Dust bag replacement display (6)
Hold the hose up into air. If the dust bag change display lights up, the bag is full.
Please change it.
Changing the dust bag
• Pull the plug out of the socket.
• Open the lid of the dust bag compartment by the handle (7).
• Remove the bag by pulling the fi xing device carefully towards the rear in order
to make the bag more easily accessible. Then remove the dust bag by pulling
it upwards.
• Insert a new bag. Please ensure that the bag is located correctly in the guide
mechanism. Close the cover so that it snaps into place.
Filter
Your appliance has two fi lters.
Motor protection fi lter (inlet fi lter):
The inlet fi lter is located in the dust bag compartment. The fi lter is located verti-
cally in the rear section of the dust housing. Remove the fi lter by pulling upwards.
Clean the engine protection fi lter after 10 dust bag changes. If necessary, the fi lter
can also be washed in warm water without any additives. Place it back into place
only once it is completely dry!
6....-05-BS 1245 41
For vacuuming upholstery, curtains and in corners
and crevices etc.
To clean carpets or smooth surfaces.
Smooth fl oors: Press down the lever with the
brush symbol with your foot. The
brush is now visible.
Carpets: Press the lever In the opposite
direction. The brushes are now
retracted.
Pull these off while turning slightly.
GB
41
25.02.2005, 14:19:26 Uhr