Concept VT5000 Bedienungsanleitung Seite 60

EN
ranges from 5 °C to 35 °C with 1 °C step each time the button is pressed.
b) When the temperature setting is activated, the temperature set previously is not changed. The temperature
only changes when you press
temperature will be saved.
c) If you do not press any button or you press any button other than
LED indicator displays
temperature is ≥ 40 °C, HI is displayed).
d) The appliance detects the temperature approximately 10 seconds after switching on. Once the appliance is in
operation for more than 10 s and the ambient temperature is at least 2 °C higher than the set temperature, the
PTC heater turns off and the low/high heating output indicator goes off. (Other indicators will not change.) If
the ambient temperature is at least 2 °C lower than the set temperature, the heating function is switched on
again and the relevant heating output indicator lights up.
7. When the timer and temperature are set at the same time, the display will alternate between the temperature
and the timer within 30-second intervals (timer display for 30 s, temperature display off
for 30 s, timer display off
temperature setting will be displayed.
8. During operation, you can press the button
lights up.
ECO mode: The default setting is 22 °C. If the ambient temperature is below 18 °C, high heating output is activated.
If the ambient temperature is higher than 18 °C, low heating output is activated. As soon as the temperature
reaches 22 °C, the PTC heater turns off. The indicator will display room temperature.
9. Memory functions:
If you press the button
time, except for the timer function.
10. If the appliance is running for at least 1 minute without any operation, the brightness of the display should be
reduced to 1/3 of normal brightness, helping to solve the problem of intense LED lighting at night. Pressing any
button resumes normal brightness.
11. When the appliance falls down during operation, the PTC heater turns off, the fan will operate for approximately
10 seconds and then switches off as well. The appliance switches to standby mode.
12. Wi-Fi function - equipment needed to be able to use the Wi-Fi function:
A. air heater, Wi-Fi router, mobile phone
B. The end appliance must have the appropriate application installed and the appliance must be connected to the
Wi-Fi router. To do this, proceed as follows:
60
or . Press the button
room temperature (if the room temperature is ≤ -10 °C, LO is displayed, if the room
timer display for 30 s, temperature display off). If the timer is not set, only the
to switch the appliance to standby mode (ECO). The indicator
in the standby mode, the appliance will operate with the same settings as the last
to exit the temperature setting and the set
, and within 5 seconds, the
temperature display
VT5000/VT5010