Positioning The Appliance; Button Functions - Concept VT5000 Bedienungsanleitung

USER MANUAL

POSITIONING THE APPLIANCE

a) Remove the appliance from its packaging.
b) Carefully place the appliance with the right side on a stable surface.

BUTTON FUNCTIONS

1. Make sure that the mains voltage corresponds to the operating voltage of the appliance (220 V - 240 V), and
connect the appliance to the mains.
2. Turn on the power switch on the back side. The beep sounds and the appliance switches to standby mode. All
functions and display will be inactive.
3. There are no active buttons in the standby mode except the button
turns on. Pressing this button again turns off the appliance. The following default settings are displayed after
turning on:
a) PTC: the indicator of low heating output will light up
up.
b) Timer: 0 h (i.e. no timer), the "
c) Temperature: display of the initial temperature. The „
4. During operation, you can press the button
again to switch to high heating output, etc.
a) Low heating output operation: low heating output indicator lights up
off).
b) High heating output operation: high heating output indicator lights up
is off).
5. During operation, press the button
a) Enter the timer setting mode, the time indicator lights up. The LED indicator will flash in half-second intervals.
Now press
decreases by 1 hour. Holding the button
quickly.
b) When you enter the timer setting mode, it does not change the timer set previously. Time only changes when
you press
c) If you do not press any button or you press any button other than
indicator lights up
reaches "0", the appliance turns off and enters standby mode.
d) If the timer is set to "0", it means that no timer is activated. The LED indicator
room temperature. The appliance switches to standby mode.
6. During operation, press the button
a) Setting the temperature: Press the button
will flash in half-second intervals. Press
0 VT5000/VT5010
" indicator is off.
to set the timer.
or to set the timer (0-12 hours). Each time you press the button, the time increases or
or . Subsequently, the newly set timer starts.
and displays the set timer. Time begins to read at hourly intervals. When the timer
to activate the temperature setting.
. Press the button
. The indicator of high heating output
" LED indicator will light up.
to change high heating output to low heating output. Press
(high heating output indicator
. (Low heating output indicator
or more than 2 seconds will change the displayed values
or
, the temperature indicator lights up
or to change the temperature. The temperature setting
EN
. The appliance
will not light
is
within 5 seconds, the LED
will go off and display
, the LED indicator
59