Horizon Hobby Spektrum SR4000T Bedienungsanleitung Seite 7

2.4GHz Troubleshooting Guide
Problem
The system will
not connect
The receiver
goes into failsafe
mode a short
distance away
from the trans-
mitter
The receiver
stops responding
during operation
Possible Cause
Your transmitter and re-
ceiver are too close together
You are near metal objects
The receiver is bound to a
different model memory
Your transmitter was
placed into bind mode and
is no longer bound to your
receiver
Check for damage on the
receiver antenna
Low receiver battery voltage
If the battery voltage is low,
it may drop below 3.5V
momentarily, causing the
receiver to brown-out, then
reconnect
Loose or damaged wires
or connectors between
battery and receiver
Solution
Move transmitter 8 to 12
feet away from receiver
Move to an area with less
metal
Make sure the correct model
memory is active in your
transmitter
Rebind your transmitter
and receiver
Make sure your receiver an-
tenna is in an antenna tube
and is above the vehicle
Replace the receiver or
contact Horizon Product
Support
Charge the receiver or
vehicle battery. Spektrum
receivers require at least
3.5V to operate
Check the wires and
connection between the
battery and receiver. Repair
or replace wires and/or
connectors
EN