Safety Information - EINHELL AFF 18 Bedienungsanleitung

Anleitung AFF 18_SPK7:_
Note the instructions for use!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Retain this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, hand over this
operating manual as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.
1. SCOPE OF USE
The ash filter can be used together with a vacuum
cleaner (not included), for vacuuming cold ash or
material from ovens, fireplaces or barbecues.

2. SAFETY INFORMATION

It is imperative to follow the information in these
operating instructions. Also, the safety
instructions and accident prevention regulations
required by the law must be observed.
Important! It is prohibited to vacuum dangerous
substances with the ash filter!
Do not vacuum ash from unacceptable fuels.
Do not use the ash filter to vacuum hot, glowing
or combustible objects (for example charcoal,
cigarettes,...).
Important! Do not vacuum soot!
Important! The material being vacuumed must
not exceed a temperature of 40°C.
Important! If the temperature of the material
being vacuumed exceeds 40°C, there is a risk of
fire.
Important! If the permissible temperature is
exceeded, there is a risk of the vacuum cleaner,
the ash filter and the hoses being damaged.
Important! Some materials can look cool on the
outside but still be hot on the inside. Hot
materials can re-ignite in a current of air.
Before you begin with the vacuuming, wait for the
material to cool down completely. Do not
extinguish hot particles of ash with water as the
sudden differences in temperature can cause
22.01.2007 16:39 Uhr Seite 7
cracks to form in your fireplace.
When vacuuming inside ovens, be certain to wait
for the oven to cool down completely as
temperatures above 40°C can damage the
vacuum cleaner and the ash filter.
While you are vacuuming, check the hoses, the
ash filer and the vacuum cleaner continually for
overheating.
If you discover overheating, switch off the
vacuum cleaner immediately, pull out the power
plug and take out the filter bag. Separate the ash
filter from the vacuum cleaner and remove the
vacuumed material. Then leave the vacuum
cleaner and the ash filter to cool outdoors under
supervision.
Important! When you are finished with your
work, empty the ash filter and the vacuum
cleaner completely as there may still be a risk of
fire.
3. LAYOUT (Fig. 1)
1. Container
2. Container lid
3. Locking hook
4. Suction hose (ash filter)
5. Suction tube
6. Connection for suction tube (ash filter)
7. Connection for suction tube (vacuum cleaner)
8. Suction tube (vacuum cleaner)
9. Vacuum cleaner
10. Filter cartridge for fine ash dust.
Important. Suction hose (8) and vacuum cleaner (9)
not included!
4. Starting up (Fig. 1/2/3)
Fit the vacuum tube (5) onto the end of the suction
hose (4); the hose ends are identical.
Fit the suction hose (4) onto the connection (6)
and turn until securely attached.
Prepare the vacuum cleaner (9) according to the
operating instructions. A filter bag must be
inserted at all events.
Fit the suction hose (8) onto the connection (7).
Switch on the vacuum cleaner (9) and start with
your work.
GB
7