Suspended Installation - Omnitronic I Serie Bedienungsanleitung

The wall-mounting must always be installed via all fixation holes. Do only use appropriate screws and make
sure that the screws are properly connected with the ground.
Procedure:
Step 1: On the wall-mounting, there are the holes for the installation.
Step 2: Hold the wall-mounting onto the location where it is to be installed.
Step 3: Mark the boreholes with a pen or a suitable tool.
Step 4: Drill the holes.
Step 5: Hold the wall-mounting in the desired position and tighten the screws.
Step 6: Insert the eye-bolts into the threaded holes. The eye-bolts must be tightened until stop position,
hand-tight and without any tools.
Step 7: Install the speaker-system on the wall-mounting.
Step 8: Insert the quick links of the safety bonds in the eye-bolts of the speaker-system. Pull the safety
bonds through the wall-mounting's safety eyelet. Insert the end in the quick link and tighten the
safety screw.
The wall mounting's maximum service life must never be exceeded.

Suspended installation

This speaker-system must only be suspended by experienced and trained persons - Danger to
Life due to crashing speaker-systems!
Trained persons are e.g. Head Rigger, Lightcrew head etc.
If you lack these qualifications, do not attempt the installation yourself, but instead use a professional
structural rigger.
If you have doubts concerning the safety of a possible installation, do NOT install the speaker-system!
The speaker-system has to be installed out of the reach of people.
The installation material must always hold at least 12 times the weight of the speaker-systems.
Please note:
You must never install one speaker-system under another!
When deinstalling the speaker-system, make sure that you insert the original screws in the threaded holes!
The I-series must only be installed via these threaded bushings strengthended with a steel angle. The drive-
in nuts must never be used for the installation! The illustrations in the annex show by the I-208, where the
steel angles and where the drive-in nuts are located.
Horizontal suspension:
Please note:
The horizontal installation must always be carried out via two
speaker-system must always be installed absolutely planar (vertical angle 90°, horizontal angle 0°).
Procedure:
Step 1: Unscrew the allen screws with a suitable allen key.
Step 2: Install the eye-bolts in the threaded holes of the speaker-system. The eye-bolts must be
tightened until stop position, hand-tight and without any tools.
Step 3: Install the the screw-on chain link in the first and last chain link and tighten the fixation screw.
Step 4: Install the chain with the screw-on chain link at the installation eyelet of the ring coupler and
tighten the fixation screw.
DANGER!
eye-bolts and appropriate chains. The
29/39 00033329.DOC, Version 1.1