Herunterladen Inhalt Inhalt Diese Seite drucken

Stacking - Omnitronic I Serie Bedienungsanleitung

Lautsprecherboxen
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Secondary attachment:
>30 mm
accordance with the latest industrial safety regulations (e. g. BGV C1, BGI 810-3).
Please note: for overhead rigging in public or industrial areas, a series of safety instructions have to be
followed that this manual can only give in part. The operator must therefore inform himself on the current
safety instructions and consider them.
The manufacturer cannot be made liable for damages caused by incorrect installations or insufficient safety
precautions!
Please note: Before installing the eye-bolts, make sure that the the thread is always in perfect condition and
free from dirt etc.
Install the eye-bolts in the threaded holes of the speaker-system. The eye-bolts must be tightened until stop
position, hand-tight and without any tools.
Insert the quick links of the safety bonds in the eye-bolts of the speaker-system. Pull the safety bonds over a
safe fixation spot. Insert the end in the quick link and tighten the safety screw.
The maximum drop distance must never exceed 20 cm.
A safety rope which already hold the strain of a crash or which is defective must not be used again.
Before taking into operation for the first time, the installation has to be approved by an expert!

Stacking

This speaker-system may only be installed on top of another speaker-system if both systems are lashed up
with each other via appropriate clamping belts and protected against flipping over.
Please refer to the instructions under Secondary attachment.
Please note: the speaker-system must always be secured via three
appropriate eye-bolts and three appropriate safety bonds.
The eyelets must always hold at least 12 times the weight of the speaker-
systems.
For overhead use, always install an appropriate safety bond.
M8
You must only use safety bonds complying with DIN 56927, quick links
complying with DIN 56926, shackles complying with DIN EN 1677-1 and
BGV C1 carbines. The safety bonds, quick links, shackles and the
carbines must be sufficiently dimensioned and used correctly in
DANGER TO LIFE!
26/39
00033329.DOC, Version 1.1

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis