CANGAROO BABYUNO Gebrauchsanweisung Seite 16

We recommend you to use of boiled or filtered water in order to reduce the risk
of limescale deposition.
ATTENTION: The electric warmer produces hot steam. Do not hold and do not put
your hands close to the product, while it works, to avoid risk from burning.
Recommendations:
- The temperature in the water will decrease with few degrees, when the
powdered milk get poured into the bottle with water.
-The temperature of the water can influence by the high or low initial
temperature.
 ATTENTION: The warmer will continue to heat until you turn the adjustment
button on position OFF or you turn it off the socket.
The final temperature of the content depends on the size, material (plastic or
glass), type and quantity of the liquid.
Do not put too much water in the device and do not warm the food for too long
time. If you use too much water, the bottle will heat too much.
Using too much water can damage the device.
If during the heating process, the indicating light is turning on, this means that
the heating process continues. If the indicating light is turning off, it means that
the appliance is saving energy and keeps warming, and the warmer is
automatically adjusting the temperature in order to allow the food to heat evenly
and completely without destroying its nutritional ingredients. During running the
indicating light will flash, which means that the product is not damaged but
automatically adjust the temperature. This must not worry you.
The following guidelines are approximate temperatures which the water in the
warmer body can reach.
Setting
A. For warming feeding bottles of all sizes and brands and jars with food (Fig.
BW1-5):
1.) Fill the warmer with 100 – 120 ml water.
2.) Put the bottle filled with water or milk in the warmer.
3.) The water should never flow over the bottle!
4.) Never fill more than 120 ml of water!
Water temperature in the container
~ 40° C
~ 70° C
~100° C
15