Installation; Adjusting The Volume; Power Connections - Mega Solaris Bedienungsanleitung

Introduction
Dear customer,
Congratulations to this
highclass carhifi-product!
With this model you have chosen best
quality united with futuristic design
and innovative functionality.
Please read manual carefully and act so,
to become full pleasure of your new audioamplification.

Installation

• Please choose well-ventilated place in the car for
installing the amplifier for preventing heat accumulation!
if you have no experience with installation of your
•
amplifier, please use the help of an authorized car-hifi dealer
in your neighbourhood .

Adjusting the volume

•
with the Gain-control you can adjust the output-power to your wishes
letf = silent7minimum, right = loud/maximum
•
Important! Before turning on the radio and the amplifier for first time, please put the gaincontrol to minimum-left!
Otherwise there is danger of damaging or destroning your carspeakers!
•
After tunring on the radio+amplifier you can carefully increase the outputpower by turing the potentiometer clockwise.
Powerconnections
• Detach the minus- cable from the car-battery
before you start ocnnecting the amplifier!!!
for power-connections use only special power-
•
cable. Connect B+ to your +12V of the battery.
GND should be connected to car-chassis.
Take the shortest way in order to avoid
possible disturbances.
Remote must be connected to switched +12V
•
contact from your car-radio.
• After all connections are made, close the
electrical-circiut by re-connecting
the minus-battery-contact.
car-hifi ampilifier Megakick „Solaris"
© Firma WJG, Braunschweig. Nachdruck oder Vervielfältigung nur mit ausdrücklicher Genehmigung
user`s manual
technical data:
power max.
power rms
frequency-range
signal to noise
distortion-factor
bass range
treble range
speaker outputs
Super Bass:
LED`s
safety
measure
accesoires
+12 V-contact
Remote-contact
GND-contact
4x250W / 2x500W
4x125W / 2x280 W
10-50.000Hz ± 1 dB
ca. 90dB
<0,05%
50-250 Hz
120-3000 Hz
4 ~ 8 Ohm
+6 ~ +12dB
LEDs for Power + Protect
Overload-, short circuit- &
thermofuse, 2 Ω
250x70x300 (350mm)mm
screwset & replaceble
fuse
751-061