Landxcape LX790 Installationsanleitung Seite 12

If your lawn has multiple areas connected to each other by a corridor, it
should be at least 1 meter wide. If the corridor is narrower than 1 meter,
TM
Landxcape will have difficulty travelling between. In this case, it is
recommended to set up a main area and a secondary area in your lawn.
The boundary wire should be placed as illustrated in the picture. When the
secondary area has to be cut, please pick up Landxcape
the secondary area. Landxcape TM will mow without problem, but you have
to bring it back to the charging base when the battery runs out.
Before it starts mowing for the first time, make sure Landxcape
working area is clear of objects such as toys and branches...
1. Set the cutting height to the maximum level 60mm.
2. Place your Landxcape TM a few meters in front of the charging base.
TM
3. Press until Landxcape turns on. For the first use, input the default
PIN code 0000 by pressing for four times when the number 0 is
blinking.
NOTE: When Landxcape
TM turns on, all lights on the display will be
illuminated and then turn off. Check if there is any light damaged. It is
recommended to shield the display with your hand when the outdoor light
gets too strong.
NOTE: Landxcape
TM
will turn off if it does not receive any input within 30
seconds after it is turned on. If you enter wrong PIN code three times,
Landxcape TM will raise the alarm "di-di" and then turn off.
EN
TM and bring it to
TM
's
Secondary area
<1m
Main area
Only for reference
11