AITECS 2016 Universal Gebrauchsanleitung Seite 63

Table 1 Guidance and manufacturer's declaration - electromagnetic emissions
Syringepump is intended for use in the electromagnetic environment specified below. The customer or the user of
syringepump should assure that it is used in such an environment.
Emission test
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations/flicker
emissions
IEC 61000-3-3
Table 2 Guidance and manufacturer's declaration – electromagnetic immunity
Syringepump is intended for use in the electromagnetic environment specified below. The customer or the user of
syringepump should assure that it is used in such an environment.
Immunity test
Electrostatic +/- 6 kV contact
discharge (ESD)
IEC 61000-4-2
+/- 8 kV air
Electrical fast +/- 2 kV for power
transient burst supply lines
IEC 61000-4-4
+/- 1kV for
input/output lines
Surge +/- 1kV
IEC 61000-4-5 differential mode
+/- 2 kV common
Compliance
Group 1
Class B
Class A
Complies
IEC 60601 Compliance
test level level
+/- 8 kV contact (1)
+/- 15 kV air (1)
+/- 2 kV for power
supply lines
+/- 1kV for
input/output lines
+/- 1kV
differential mode
+/- 2 kV common
mode mode
GEBRAUCHSANLEITUNG
Electromagnetic environment -
Syringepump uses RF energy only for its
internal function. Therefore, its RF emissions
are very low and are not likely to cause any
interference in nearby electronic equipment.
Syringepump is suitable for use in all
establishments including domestic
establishments and those directly connected
to the public low-voltage power supply
network that supplies buildings used for
domestic purposes.
Electromagnetic environment - guidance
Floors should be wood, concrete, or ceramic tile. If the
floors are covered with synthetic material, the relative
humidity should be at least 30%.
Mains power quality should be that of a typical
commercial or hospital environment.
Mains power quality should be that of a typical
commercial or hospital environment.
AITECS 2016
guidance
63