Connecting Wires To Terminals; Optional Accessory - Kenwood DMX5020DABS Kurzanleitung

Ñ

Connecting wires to terminals

Light Blue/Yellow (Steering remote control wire)
To steering remote
To use the steering wheel remote control feature,
you need an exclusive remote adapter (not
supplied) matched to your car.
Light Green (Parking sensor wire)
Accessory 3: Parking Extention cable
Connect to the vehicle's
parking brake detection
switch harness.
Purple/White (Reverse sensor wire)
Connect to vehicle's
reverse lamp harness
when using the
optional rear view
camera.
Connector A
Connector B
ISO Connector
[1] USB maximum power supply current :
DC 5 V = 1.5 A
[2] Sold separately
[3]

Optional accessory

For best safety, be sure
to connect the parking
sensor.
1 3 5 7
2 4 6 8
1 3 5 7
2 4 6 8
Fuse (15A)
REAR OUT
CAM IN
Connect to vehicle's steering remote harness.
Contact your KENWOOD dealer for details.
ST REMOTE
Bright Green/Red
INPUT 1
ST REMOTE
Purple/Red
INPUT 2
ST REMOTE
Gray/Red
GND
USB terminal (1.0 m)
[1]
5V = 1.5A
Subwoofer Preout
Φ 6.5 mm (maximum)
# CAUTION
Use of a CX-DAB1 (optional accessory)
as a DAB antenna is recommended.
When using a commercially available
DAB antenna, the diameter of the SMB
connector must be Φ 6.5 mm or less.
1 2 3 4
AV-IN
[2]
video, 3; Ground, 4; Right audio).
Rear Audio Preout
(Left; White, Right; Red)
FRONT OUT
Front Audio Preout
(Left; White, Right; Red)
Visual Output (Yellow)
VIDEO OUT
Rear view camera input (Yellow)
Connection/Installation
USB device
Cap
SUB
WOOFER
Accessory 1:
Bluetooth Microphone
FM/AM antenna
DAB antenna
CX-DAB1
(1; Left audio, 2; Composite
English
[2]
Cap
[3]
27