Bestway aquatronix 58482 Bedienungsanleitung Seite 7

11
11
TrouЫeshooting
ProЫem PossiЫe
Cause Solution
Battery is low. Charge the robot again.
Power off the robot and visually check the hole under the debris.
lf necessary, contact your dealer for furthe r instructions.
lmpeller is jammed.
WARNING!
Make sure the robot is pow ered off before
Robot does not capture debris.
servicing the device.
lmpeller is broken. Contact your dealer for replacement.
Debris compartment is full. Clean the debris compartment and filter cover.
Robot stopped
Ьу
obstacle.
Check to see that if th ere is object obstructing the cleaner.
Robot stopped moving in the middle of
Remove th e obstacle.
pool(swivel head still turning).
Robot is stopped
Ьу
suction force
Turn off the filtration system(See instructions in manual).
from main pool floor drain.
Debris compartment is full. Clean the debris compartment
Operation time is shorter than Clean the filter compartment and recharge th e robot again for
expected. 4.5- 5 hrs
Moving direction is interrupted
Ьу
Robot does not cover the entire pool/
water circulation generated
Turn off the filtration system(See instructions in manual).
Ьу filtration system.
move along the pool wall.
Wheel is jammed. Check and clean out debris from the wheel.
Locking pin position is not correct 1
Follow manual instructions to set up the locking pin position
bumper is required. properly and apply bumper.
Robot moves along the pool wall of Make sure the bumpers have been installed(See instructions in
round pool. manual).
Robot trapped in the narrow place ofthe Not enough space for robot to change
Follow manual instructions to pu t bumper on both ends of robot .
in-grou nd pool.
directions.
Robot moves slowly. Debris compartment is full. Clean the debris compartment and filter cover.
Swivel head bottom is jammed.
Check and remove any debris that may Ье trapped under the
swivel head.
Swivel head does not turn ог turns
Side flap is jammed.
Check and remove any debris that hinders the movement of the
noticeaЫy
slowly.
flap.
Swivel smoothing- ring is broken.
Replace with а new swive l smoothing-ring. Contact your dealer
for replacement parts .
Suction mouth's flap
(оп
cleaner
Suction mouth's flap works like
а
door to prevent the debris
bottom) is broken.
from escaping from th e debris compartment. Contact dealer for
Debris escapes from the robot.
replacement parts and instruction.
Draining filter plate is broken ог not in Make sure the draining filter plate is in place and replace а new
place. one if necessary before next use.
Debris goes outside the filter cover. Filter cover net is damaged.
Re place with а new filter cover. Contact you r dealer for
replacement parts .
Float sinks. Float is broken and water goes in.
Replace with а new float. Contact your dealer for replacemen t
parts.
Contact dealer for battery replacement.
WARNING!
Battery is damaged.
DO NOT open the robot and replace the battery
Ьу
you rself. This
could resu lt in severe о г fatal inj uries and the warranty wil l Ье
voided as
а
result.
Robot cannot
Ье
charged 1 recharged.
Charging саЫе is not completely
Make sure that th e charger саЫе is connected with external
connected with external adaptor and
adaptor and robot prope rly and completely.
roЬot.
Refer to instruction manual.
Contact dealer for replacement.
External adaptor is out of order.
WARNING!
Using th e wrong exte rnal adaptor will result
in damaging the robot 1 battery and voiding the warranty as а
result.
7
ЗОЗО21219122_58482_21х28.5сm_ ~J,J~it!J,iifii!!ti<'ffЛ.~).jj/Jjj
i! _
~