Assembling A Stack - Dell PowerConnect 6200 Serie Erste Schritte

Figure 1-2. Connecting Power Cable

Assembling a Stack

You can stack PowerConnect 6200 series switches up to 12 switches high, supporting up to 576 front panel ports.
Create a stack by connecting adjacent units using the stacking ports on the left side of the switch rear. See
Figure 1-3.
NOTE:
The switches must be turned off as they are added to a stack.
Install a separately purchased stacking module in rear "Bay 1" in each of the switches to be stacked.
1
Use the cables supplied with the stacking modules to connect from one switch to the next until all switches
2
are connected in a ring.
Make sure that the last stacking cable is connected from the last switch to the first switch to create a loop.
3
If necessary, use a separately purchased three-meter stacking cable to connect the switches.
4
8
Getting Started Guide
Downloaded from www.Manualslib.com manuals search engine