GreenWorks BLG304 Bedienungshandbuch Seite 5

EN
1 DESCRIPTION
1.1 PURPOSE
The machine is used to propel air out of a tube to move
unwanted materials such as leaves in the yard. Some
machines also suck in leaves and small twigs through a
vacuum, and shred them into a bag.
1.2 OVERVIEW
Figure 1 - 4.
1 On/off button /
Speed button
2 Large nozzle
3 Small nozzle
2 SAFETY
Make sure that you do/obey all safety instructions.
Refer to Safety Manual.
3 INSTALLATION
3.1 UNPACK THE MACHINE
Make sure that you correctly assemble the machine
before use.
• If the parts have damage, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the
service center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with
local regulations.
3.2 INSTALL THE NOZZLES
Figure 2.
1. Move the large nozzle over the outlet opening on
the machine.
2. Push the nozzle until the latch on the machine
engages into the opening on the nozzle.
4 Latch
5 Opening
WARNING
WARNING
WARNING
English
3. Move the small tapered nozzle over the large
nozzle.
4. Push the small nozzle until the latch on the large
nozzle engages into the opening on the small
nozzle.
3.3 INSTALL THE BATTERY PACK
Figure 3.
• If the battery pack or charger is damaged, replace
the battery pack or the charger.
• Stop the machine and wait until the motor stops
before you install or remove the battery pack.
• Read, know, and do the instructions in the battery
and charger manual.
1. Align the lift ribs on the battery pack with the
grooves in the battery compartment.
2. Push the battery pack into the battery compartment
until the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
3.4 REMOVE THE BATTERY PACK
Figure 3.
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
4 OPERATION
Make sure the blower tube is in position before
operation.
4.1 START THE MACHINE
Figure 4.
The machine has a speed button to adjust the air
velocity.
1. Push the on/off button in the 1 or 2 position.
4.2 STOP THE MACHINE
Figure 4.
1. Push the on/off button in the off position.
4.3 OPERATION TIPS
• Blow around the outer edge of the unwanted
materials to prevent the unwanted materials from
scattering.
• Use rakes and brooms to clear the unwanted
material before you blow.
4
WARNING
WARNING