Elkron HP600 Schnellanleitung Seite 5

ENGLISH
1. Mounting holes
2. CC input terminal board
Not used.
3. Power switch
The switch comprises 3 positions:
BT4: the siren is powered by a configuration with 4
alkaline batteries.
Off: the siren is not battery powered.
BT2: spare configuration.
State indications
The siren can activate the following states when the system is turned on/off.
Armed/Partially armed
Disarmed
Armed with battery low
Disarmed with battery low
Armed with Tamper open
Disarmed with Tamper open
Entrance/exit sounds
* The audio indications of the siren also relate to the settings made on the control unit. Refer to the programming manual.
Dip switch configuration
The Dip Switches are used to determine the different functions of the siren.
When the switch is moved to "ON", the switch is ON. When the switch is OFF it is moved to the opposite part.
QUICK GUIDE
HP600
OUTDOOR SIREN WITH FLASHER
4.
5.
6.
7.
8.
9.
10.
11.
12.
Siren audio
1 beeps*
2 beeps*
3 beeps
3 beeps
5 beeps
5 beeps
Countdown beeps
LED group 3
LED group 2
Cover fixing screw
LED group 1
Configuration DIP Switch
Learning button
Battery housing
Tamper switch
Base
Light alarm indication
3 LED groups blink once
Blinking in sequence for 1 cycle
3 LED groups blink 3 times
Blinking in sequence for 3 cycles
3 LED groups blink 5 times
Blinking in sequence for 5 cycles
DS80HP8A-002