Connection Of An External Preamplifier Or External Power Amplifier - VINCENT tubeLine SV-737 Bedienungsanleitung

CONNECTION OF A RECORDING DEVICE
If you want, you can use the RCA sockets "REC OUT" (17) on the back of the appliance to connect an
analogue stereo recording device (e.g. CD recorder, cassette recorder etc.) or another appliance that is
intended for receiving the unchanged, fixed stereo output level (line level) from the signal source selected
on the amplifier at any given time. The output level is independent of the Volume setting, the Loudness
function and the Tone control (BASS, TREBLE, TONE). Please note that while the preamplifier is muted (18)
the recording output is switched off.
SV-737
Connect this signal output to the signal input ("LINE IN", "TAPE IN" or "REC IN") on the recording appli-
ance using RCA cables. Please note that some recording equipment can have a slightly detrimental effect
on the audio signal quality. Some recording devices have rather low input impedance, which can slightly
alter the input signal voltage. For maximal music enjoyment we recommend that you connect to the "REC"
terminal only for as long as the recording is actually being made.
CONNECTION OF AN EXTERNAL PREAMPLIFIER
OR EXTERNAL POWER AMPLIFIER
On the SV-737 you have the possibility to split the preamp and the poweramp. If you want to use the
SV-737 as power amplifier only, please remove the bridges of the connections PRE / MAIN (16). After
that you can connect your external preamplifier to the connector "MAIN".
SV-737
If you want to use the SV-737 as a preamplifier only, pleas remove the bridges of the connections PRE /
MAIN (16). After that you can connect your external power amplifier to the connectro "PRE".
SV-737
RCA connection
LINE IN
INPUT
INPUT
Recording device,
e.g. tape recorder
Preamplifier
Power Amplifier
Vincent
35