RAVAK EVOLUTION Montageanleitung Seite 2

GB
MOUNTING INSTRUCTIONS
FOR THE EVOLUTION HANDLE
BASIC MOUNTING KIT
1. PU handle
2. Galvanized screw M8x35mm
3. Galvanized washer
8.5mm diameter
4. Nut M8
5. Template
The handle must be mounted before installation of the bathtub. It cannot be mounted afterwards!
1
2
3
4
5
1
3
2
4
6
7
tel.: 318 427 111, 318 427 200, fax: 318 427 269, 318 427 278, e-mail: smith@ravak.cz, www.ravak.com
The manufacturer reserves the right to change the price, technical parameters or other facts without
1 pc
2 pcs
2 pcs
2 pcs
2 pcs
We recommend that you test the handle in different positions until the correct position for you
has been found. Mount the handle on the upper rounded edge of the bathtub. The slight
springiness of the handle allows it to be pressed into the exact place against the wall of the
bathtub.
Place the handle into the desired position and with a soft pencil mark the exact shape of the
seating part of the handle onto the bathtub.
Recommended location of the handle is on the inner side of the upper bathtub edge, directed
sideways upward, so that uppermost point of the handle arch is at the same level as the top of
the bathtub rim (see pic. 2).
Remove the backing paper from the template and seat the clear, self-adhering foil of the
template over the pre-marked shapes on the bathtub. Adjust it so that the shape of the
template is symmetrical to the shape marked on the bathtub. ATTENTION: the templates are
not symmetric!Follow the same steps for the other side of the handle. Visually check that the
marked holes are correct by placing the handle over them.
In the marked places on the inner side of the bathtub, drill holes of 2.6mm in diameter. Now,
widen the holes to 8.5mm. Drill very carefully! Use only light pressure when drilling quickly
and keep the drill upright (on the same angle as the threads of the handle).
Before final placement of the handle, place a small amount of silicone on the outer side of the
holes, under the washers.
Put the handle in place and tighten the M8 screws and washers from the under side of the
bathtub. (Slight adjustments can be made by drilling the holes to a maximum of 10mm!).
Tighten the screws normally. Over-tightening of the screws can cause deformation of the
handle.
RAVAK a.s., Obecnická 285, 261 01 Pøíbram 1, ÈR
a prior notice and shall bear no responsibility for the printing errors.
Mount the handle on the central
p a r t o f t h e E V O L U T I O N
bathtub, near the overflow.
Design of the handle is in
harmony with the bathtub
outlines.