Maintenance - eta Formio Bedienungsanleitung

GB
Note
Some ingredients require stirring or shaking during cooking. However, never press the
locking latch of the handle – it only serves to deliberately pull out the A6 container from
the A5 drip tray. At the same time, do not turn or tilt the container excessively when
shaking, the drip tray may contain hot liquid.
IV. MAINTENANCE
Before carrying out any maintenance disconnect the appliance from the power grid
by pulling out the plug on the power cord from the el. socket and allow it to cool
down! After each use wipe the outer surfaces with a soft damp cloth. Do not use abrasive
and aggressive cleaning agents and metal tools, which could scratch the surface during
cleaning.
Wipe the outer casing with a damp cloth. Wash both containers in hot water with detergent,
then rinse with clean water and allow to dry sufficiently (only these parts can be put into
dishwasher). If necessary, gentle degreasing agents can be used on these parts. Carefully
wipe the inside of the fryer base using a damp cloth or a non-abrasive cleaning sponge. If
necessary, remove residual dirt from the heater using a cleaning brush.
Never dry plastic moulded parts above a heat source (e.g. fire stoves, electric/gas stoves,
etc.). It is normal for the colour of the surface to change over time. This change in no way
changes the properties of the surface and is not a reason for complaint about the appliance!
Wipe the power cord A11 with a cloth. Store the appliance thoroughly cleaned in a dry, dust-
free location that is out of reach of children and incapacitated persons.
V. ECOLOGY
If the size of the appliance allows, all the parts contain marking of the materials used for
production packaging, components and accessories as well as for recycling. The symbols
on the product or in the accompanying documentation mean that the electrical or electronic
product used must not be liquidated together with communal waste. To ensure the
appropriate liquidation take the used appliance to a collection point where it will be accepted
free of charge. Correct liquidation of the product helps to protect valuable natural resources
and helps to prevent a potential negative impact on the environment and human health which
can be the outcome of inappropriate liquidation of waste. More details can be obtained from
your local authorities or the closest collection point. Inappropriate manipulation of such waste
can result in a fine according to the national legislation.
Maintenance of a serious nature or maintenance which requires interference with
the internal parts of the appliance must be carried out by a professional service
centre! By failing to follow the instructions issued by the manufacturer, the right to
the warranty service will be invalidated!
20 / 37